832 ，945分通过 还剩下路由，加油。

swiftliu

考试比较顺利，有人说考满分不太好，思科会查，也不知道真假，就故意把最后一道题选错了。
9 D3 ]$ R! Q4 D, p4 V2 N8 x2 D1 M7 t8 b考试时候用万金油答题板把十三道题都写好，然后在一题接一题的abort. 选择题抽了三道，没有拖图题。
我采用了一个老外写的答题方法，比较简便，总共只用三个命令 Ipconfig, ping $sh run. 只用ping 各个路由的loopback地址就可以解决了。很方便的。有需要的咱们可以讨论一下子。

# F: M+ u+ |! `1 j+ e还剩路由了，二月份之前一定要拿下了，时间紧啊，有考过路由的同学们咱们请给予指点。
* o% q% F9 ]5 I( u感谢鸿鹄三客服冯美女的大力支持。

8 s- D; r. Q; a- O& }* ^% n9 s* Y

f13869230104

cc发型乱了

拿分走人呵呵，楼下继续！

gongvi

路由简单，，，，，不用怕，，，

royyou

排错给个方法好吗？

swiftliu

gongvi 发表于 2014-12-15 10:03
路由简单，，，，，不用怕，，，

' D) ]4 g+ q- w7 }5 G路由怎么准备比较好？

swiftliu

royyou 发表于 2014-12-15 10:16
排错给个方法好吗？

, h4 }2 \6 N$ a5 ?$ Z  `我用的是下面的方法。特简单
$ ]8 h! h8 @/ G' T
I had three MCQ’s, No Drag and Drop, And 13 Trouble Tickets in my exam. I had No IP Helper Ticket and No Wrong EIGRP AS Ticket in my exam. It was one of the easiest exam in CCNP and i finished my exam with in one hour. I only used 3 commands for all trouble tickets i.e. Ipconfig, Ping and Show Running-Configuration. 3 MCQ’s came first and then 13 trouble tickets. I opened all 13 tickets one by one and was noting down the faults and IP’s on provided board. i used abort function for all 13 tickets and didn’t submitted any ticket until i was 100% sure about the fault.

2 t5 R. M# H$ qFirst of all i submited HSRP(DSW1) and IPV6(R2) tickets which were the easiest one’s to solve.

Then i submited 4 tickets where client was getting 169.x.x.x IP Address
1st was Port Security (ASW1)
2nd Access Vlan 10 (ASW1)
3rd Switch To switch connectivity (ASW1)
7 t2 d! \: O  g4 j4th DHCP Excluded (R4)

  G6 y7 i" d' N$ Q8 e, kThen i Submited 3 tickets where client 1 was getting 10.x.x.x IP Address and was able to ping R1
" {: x$ `1 ~& [% e# F! N2 z1st was BGP Neighbour (R1)
, M! e$ _* A7 k5 ?( y: F2nd ACL (R1)
3rd NAT (R1)
) w  |. ]8 w; a  P
& T  O1 Q8 ]  T6 O# P, c' zThen i submited 1 ticket where Client 1 was getting 10.x.x.x IP address but was not able to ping R1 but was able to ping R2
: w# k2 ]! X4 P: E# D
- r* S0 I, [  E. T0 a7 X' WThat was OSPF authentication (R1)
+ Z! ]8 ?) ]; ]; T! k
; A6 Y2 [7 I2 ?' D0 J% X5 nThen i submited 2 ticket where Client 1 was getting 10.x.x.x IP address but was not able to ping R1 and R2 routers
$ \2 \6 o! b' ]0 @/ m- k: v1st was EIGRP passive interface default (R4)
2nd was EIGRP>OSPF Redistribution (R4)

6 }5 d% Z' ]3 }- y. r1 t# pLastly i submited 1 ticket where client 1 was getting 10.x.x.x IP address but was not able to ping R1, R2 and default gateway of client.
7 [" F$ [! F% y% E# n$ xIt was VLAN Filter (DSW1)

3 W' z# }& u$ z: r+ }# XMy advice to all of you is that don’t submit any ticket in first go, use the abort button for all tickets and note down the ip address and faults of all tickets on provided sheet and start submitting tickets one by one once you are 100% sure about the faults, this is because configurations of all tickets are very similar to each other.
5 Q( ?2 F; v. ~' t! `

Rockyw

恭喜，恭喜

C.C.I.E

漂亮~

國士無雙

gongvi 发表于 2014-12-15 10:03
* X$ ~3 c% i6 h4 V8 K. W5 |' T路由简单，，，，，不用怕，，，

路由题目那么多？简单？

royyou

太棒了，感谢楼主

Rockyw

恭喜，恭喜

leilei123056

太棒了，感谢楼主

Rockyw

太棒了，感谢楼主

leilei123056

拿分走人呵呵，楼下继续！