思科3650交换机密码恢复（注意不是3560）

小乔

思科新产品3850   3650 带WLC无线控制器功能，有几大亮点可看，但是我这里不多描述，入重点。
思科3650交换机的密码恢复与之前的方法是不一样的，具体官方配置方法如下，就算现在用不到，以后都会用得到，各位先了解也好！
Here is a link that points to performing a password recovery on a 3650 switch.

Here is a link that points to performing a password recovery on a 3650 switch.

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3650/software/release/3se/system_management/configuration_guide/b_sm_3se_3650_cg.pdf



SUMMARY STEPS
1. Connect a terminal or PC to the switch.
2. Set the line speed on the emulation software to 9600 baud.
3. Power off the standalone switch or the entire switch stack.
4. Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while
the System LED is still flashing green. Continue pressing the Mode button until all the system LEDs turn
on and remain solid; then release the Mode button.
5. After recovering the password, reload the switch or the active switch .
6. Power on the remaining switches in the stack.



DETAILED STEPS
Step 1 Connect a terminal or PC to the switch.
• Connect a terminal or a PC with terminal-emulation software to the switch console port. If you are recovering the
password for a switch stack, connect to the console port of the active switch or
• Connect a PC to the Ethernet management port. If you are recovering the password for a switch stack, connect to
the Ethernet management port of a stack member .
Step 2 Set the line speed on the emulation software to 9600 baud.
Step 3 Power off the standalone switch or the entire switch stack.
Step 4 Reconnect the power cord to the or the active switch. Within 15 seconds, press the Mode button while the System LED
is still flashing green. Continue pressing the Mode button until all the system LEDs turn on and remain solid; then release
the Mode button.
•
Switch:
Xmodem file system is available.
Base ethernet MAC Address: 20:37:06:4d:e9:80
Verifying bootloader digital signature.
The system has been interrupted prior to loading the operating
system software, console will be reset to 9600 baud rate.

proceed to the Procedure with Password Recovery Enabled section, and follow the steps.

游客，如果您要查看本帖隐藏内容请回复

loveshuai13

wells_1188

看看~~~~~~~~~~~

wells_1188

看看~~~~~~~~~~~~~

wells_1188

看看~~~~~~~~~~~~~

wells_1188

看看~~~~~~~~~~~~~~~

wuxiaowuwu

谢谢了谢谢了

wuxiaowuwu

谢谢了谢谢了
！！！！

icedargon

谢谢啊

Rockyw

感谢楼主分享！

大耳朵的小兔子

想看看呢

Lesson9527

DDDDDDDDDDDDDDDDDDDDDDDDDd

starswjw

学习学习

江振辉

的点点滴滴多多多多多多多多多多多多多多错

张越

6666666