300-135 914pass

sxsl761130250

登录/注册后可看大图 2 x+ S+ d2 j* _2 D首先，谢谢鸿鹄，感谢各位提供战报的战友，2018 CCNA CCNP收官！！！ - v; @% a( `2 e# H9 {# M 0 e9 H9 v& y) c  F2 }% _# c) }' S' P; U9 `4 i; d + z& t8 m- M% o$ L+ M1 R6 i6 j$ `选择题，HSRP, BGP SIM不多说，1209题库全覆盖。 ! d" t3 n2 C# s10道TT分别考了 6 R+ A/ E7 {" U' B* I8 [R2 T10 IPv6 OSPF # i9 D* y: ]  I! x* \9 n# fR3 T12 IPv6 Tunnel: O* s; E5 w( m- c ; }+ L% h( G7 ]6 E" ?R1 T13 BGP neighbor/ x7 ?* j8 J' D( N8 ^" t       T2 IP NAT R4 T7 redistribute route-map # e+ G! C7 b; T& \     T9 eigrp passive interface7 F$ t& R" L" E6 A% \ DSW1 T4 VLAN Filter ! Q+ [8 z, x- B: WASW1  T5 switchport vlan6 ^4 b' k$ l* }, P0 e. i 9 e7 z- a$ n4 g2 v          T6 switchport trunk           T15 Port Security ) {* {; v& a: E5 l) @# h' U7 o $ V* X4 a0 E8 c+ O9 ?

seyt5200

恭喜

鱼蛋

虽然战报大家分享是应该的，但是别直接复制别人的战报贴到自己的帖子啊兄弟。。。

sxsl761130250

鱼蛋 发表于 2018-12-12 14:15
虽然战报大家分享是应该的，但是别直接复制别人的战报贴到自己的帖子啊兄弟。。。

考的一模一样顺手复制了

water40tw

直接记答案可不可以pass,不去show看配置...
& @$ a/ ^8 }1 T9 S7 k

goku123

water40tw 发表于 2018-12-12 16:06
直接记答案可不可以pass,不去show看配置...

7 R  z3 t3 C7 p% z& l( ?- K8 z; d6 lIt is impossible to do it as you don't know which tickets they will ask you on the exam.
So, you should ping and check each device in order to find the errors and solutions. Otherwise, you may choose the wrong answer and then it may affect next tickets . - lose marks and fail...
* N; A" ^( a$ Q9 J0 i
Some of my suggestions have been provided below:
; f: p# l; N  j6 ^. u1st - you need to justify ipv4 question or ipv6 question
+ M. y1 E. l2 N1 D5 G' g: b2nd - for ipv4 question
3 J+ L- Y: V1 P, Rping 10.2.1.1 (DSW1) on client -> fail _> check DSW1 (vlan filter) and ASW1  (port security / access vlan / switch to switch trunk)
if ping 10.2.1.1 -> ok, then ping 10.1.1.10 (R4) -> fail and then check R4 (eigrp passive interface and redistribution route-map ospf -> eigrp )
if ping 10.1.1.10, then ping 10.1.1.2 and 10.1.1.1 -> pass  and then check R1 (BGP / NAT/ NAT ACL / R1 ACL)  , normally , R1 (always asks bgp and NAT only)
if ping 10.1.1.1 -> fail , then check R1 and problem should be ospf authentication (but this question should seldom be asked. )
, M0 x- b+ g) _+ ^" O" _
8 u6 w0 e( V; d5 c( D( n  z
For ipv6
4 w% l8 L: J0 D2 X  C2 DR2 - ospf    on s0/0/0.23     -  area 0
show ipv6 ospf neighbor   -> no neighbor on R3  
! K0 q1 A0 n$ Y! W9 D5 y- sshow run   
0 r' G, }3 C. K) smissing ipv6 ospf 1 area 0 on s0/0/0.23 (R2).
8 U) T! T; H5 E$ [
R3 - tunnel
show ipv6 ospf neighbor   - no neighbor on tunnel (R3) on R4.
show run   on R3 and R4

( Y; H0 k, l# ]$ ~' ]: Uremove tunnel mode ipv6 on tunnel   (R3).

( h) z9 P2 r! e$ Z$ v* _+ M8 g

masti0618

想请问楼主是看哪个图呢？
备考辅助活页夹下有很多个

Herbarson

tom324077

恭喜過關

201901012019

恭喜

playzone

thank you for sharing!

davidsonemo

Congratulation ? Thanks a lot for the dreadlord !

harryk53

Thanks for sharing!