成长值: 63715
|
本帖最后由 小乔 于 2023-1-6 16:50 编辑
Lab Objective:
The objective of this lab exercise is for you to learn how to configure EIGRP running IPv6
Lab Purpose:
Certification Level:
This lab is suitable for ICND2 certification exam preparation.
Lab Difficulty:
This lab has a difficulty rating of 7/10.
Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 20 minutes.
Lab Topology:
Please use the following topology to complete this lab exercise
Task 1:
Configure hostnames on R1, R2, R3, and R4 as illustrated in the topology.
Task 2:
Configure each router with its respective IPv6 addresses and Gigabit interfaces, and make sure that your router is ready to route IPv6 traffic.
Task 3:
Configure EIGRP for IPv6 in the network as follows
All the routers will be inside ASN 100
There are no IPv4 addresses at all so manually create a router ID for each router (different on each unit) and
Make sure that you advertise every network shown in the diagram (including Loopbacks)
Task 4:
Make sure that you can ping from R2 Loopbacks to R4 Loopbacks to ensure that there is full connectivity.
Task 5:
To see the EIGRP database, provide the following information from R1
show ipv6 eigrp neighbhors
show ipv6 eigrp topology
show ipv6 route
Configuration and Verification
Task 1:
For reference information on configuring hostnames, please refer to earlier labs.
Task 2:
For reference information on configuring IPv6 and IPv6 interfaces, please refer to earlier labs.
Task 3:
Task 4:
Task 5:
来源: CCNA LAB 80: Configuring Multi-Area OSPF
来源: CCNA LAB 81: Debugging OSPF Adjacencies
来源: CCNA LAB 82: Configure, Verify, and TS OSPFv3 for IPv6
来源: CCNA LAB 83: Configuring Basic EIGRP Routing
来源: CCNA LAB 84: Configuring EIGRP Routing Using Wildcard Masks
来源: CCNA LAB 85: EIGRP Automatic Summarization
来源: CCNA LAB 86: Passive Interfaces for EIGRP Updates
来源: CCNA LAB 87: Summarizing Routes with EIGRP
来源: CCNA LAB 88: Verifying the EIGRP Database
来源: CCNA LAB 89: EIGRP Split Horizon
|
-
|