CCNA LAB 53: Configuring an Enable Secret Password and Exec Timeout on Catal...

小乔

Lab Objective:
The objective of this lab exercise is for you to learn and understand how to configure a switch to be secure on the console port with a timeout value and protect enable mode with a secret password.


Lab Purpose:
Console access configuration is a fundamental skill. Switches are always configured first via console access because there is no Telnet access configured. As a Cisco engineer, as well as in the Cisco CCNA exam, you will be expected to know how to configure a switch to allow access via the console as well as set a timeout value when the session is idle.

Certification Level:
This lab is suitable for CCENT certification exam preparation.

Lab Difficulty:
This lab has a difficulty rating of 5/10.

Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 5 minutes.

Lab Topology:
Please use the following topology to complete this lab exercise:




Task 1:
Configure a hostname on Sw1.

Task 2:
Set a password on the console line of HELLO. Set an exec timeout on the console port of 5 minutes and 30 seconds.

Task 3:
Set the enable secret password CISCO. Test the connection if you have console access to your device.


Task 4:
Check the show run. The passwords are encrypted by default.

Configuration and Verification
Task 1:
For reference information on configuring hostnames, please refer to earlier labs.

Task 2:
Sw1(config)#line console 0
Sw1(config-line)#password HELLO
Sw1(config-line)#exec-timeout ?
<0-35791>  Timeout in minutes
Sw1(config-line)#exec-timeout 5 ?
<0-2147483>  Timeout in seconds
<cr>
Sw1(config-line)#exec-timeout 5 30
Task 3:
Sw1#conf t
Enter configuration commands, one per line.  End with CTRL/Z.
Sw1(config)#enable secret CISCO
Sw1(config)#
Task 4:
Sw1#show run

hostname Sw1
!
enable secret 5 $1$mERr$NJdjwh5wX8Ia/X8aC4RIu.


来源: CCNA LAB 49: Configuring Passwords on Catalyst Switches
来源: CCNA LAB 50: Permitting Telnet Access to Catalyst IOS Switches
来源: CCNA LAB  51: Permitting Telnet Access to Catalyst IOS Switches—Login Local
来源: CCNA LAB 52: Permitting Console Access to Catalyst IOS Switches—Login Local