300-410 pass 901 21/12/2020

slourock91

There are many new questions compared to the dump 9/15, I use dump 147 questions.

nlee01

恭囍樓主

goku123

thanks for sharing

goku123

could you remember which new questions ?
" V) f' s- A) g  N- x( r5 L2 d+ |i will take 300-410 exam later .

" ], U3 F6 h/ estill waiting for 300-410 dump update

goku123

how many MC and Draw and drop questions? any simulation questions?

细雨煮咖啡

congratulation！

441755437

congratulation！wonderful

441755437

congratulation,wonderful

441755437

you ae wonderful

slourock91

+ r2 L  k. d7 B4 x( n; s
! H9 z3 t/ V8 G9 P, h# v

slourock91

What destination addresses does EIGRP use when feasible?(Choose two.)

A.    IP address 224.0.0.9
B.    IP address224.0.0.10
C.    IP address 224.0.0.8
$ t% e5 t  w5 E, h. AD.    MAC address01:00:5E:00:00:0A
% P* V; D+ e4 n: \$ @. U2 i& }+ {# pE.    MAC address 0C:15:C0:00:00:01

How are packets forwarded in an MPLS domain?

A.    Using the destination IP address of thepacket.
! w6 D  S4 T; G( }+ C, aB.    Using the source IP address of the packet.
C.    Using a number thathas been specified in a label.
) @5 Y- \' Z1 Y, UD.    Using the MAC address of the frame.

7 {. c! H) v3 |0 D* `( B* GYou just discovered that a ping packet sent from one of the devices to anothertook a different path in the return than it did on its way to the destination.What behavior caused this?

A.    Windowing
B.    Global synchronization
C.    MSS
D.    Asymmetric routing

0 v; v4 Y/ V2 M* x1 @! n& U; N. gHow long is the default NHRP cache timer?

A.   2 hours
B.    1 hour
C.    30 minutes
D.    15 minutes

2 T, M0 a& z/ bA network engineer needs to verify IP SLA operations on an interface that showson indication of excessive traffic. Which command should the engineer use tocomplete this action?

A.    show frequency
$ R1 v, G8 J$ ?) M. @" I* ZB.    show track
: w* }% F+ r; RC.    show reachability
D.    show threshold

# `3 Y, |) ?: K+ ]  ]& {7 @/ P$ DThe OSPF dead interval defaults to how many times the hello interval?

A.    Two
B.    Three
C.    Four
D.    Five

7 z2 y! F3 `, t! ]( F. y* {% c+ `Which statement about MPLS LDP router ID is true?

A.   The loopback with the highest IP address is selected as the router ID.
  i' X- ^7 _( `B.    If MPLS LDP router ID must match the IGP router ID.
C.    The force keyword changes the router ID to the specificaddress causing any impact.
D.    If not configured, the operational physical interface ischosen as the router ID even if a loopback is configured.

' W/ o$ `% `5 v, RHow are customer routes isolated on PE routers in an MPLS Layer 3 VPN?

A.   By using VRF
B.    By using VDCs
C.    By using MP-BGP
& O" c* N% s5 G0 ~, a" VD.    By using LDP

The OSPF database of a router shows LSA types 1, 2, 7, and 3 default routeronly. Which type of area is this router connected to?

A.    stub area
' a9 ?% ~4 q7 d; y! f) `, _8 o; GB.    totally stubby area
C.    NSSA totally stub
' S6 a9 z( m" M2 _" MD.    NSSA

8 D* Y7 y. T# U' [Which three IP SLA performance metrics can you use to monitor enterprise-classnetworks? (Choose three.)

A.   Packet loss
B.    Delay
! V( I+ J2 u! t3 D7 k7 F2 p/ DC.    bandwidth
D.    Connectivity
  |+ {6 d, y* l6 fE.    Reliability
F.    traps

A network administrator notices that the BGP state drops and logs are generatedfor missing BGP hello keepalives. What is the potential problem?

A.    Incorrect neighbor options.
0 X2 s% e# x4 A# E0 YB.    Hello timer mismatch.
2 O6 ^' w3 p7 x, Y! VC.    BGP path MTU enabled.
+ q0 Z/ X0 l0 G" f4 pD.    MTU mismatch.

slourock91

1 P! q. q7 B' p$ c

Which access list entry checks for an ACK within a packetheader?

A.    access-list 49 permit ip any any eq 21tcp-ack
" j4 U: s5 n; E' IB.    access-list 49 permit tcp any any eq 21 tcp-ack
/ H" i# A) F: Q+ ^) K/ c' TC.    access-list 149permit tcp any any eq 21 established
D.    access-list 49 permit tcp any any eq 21 established

" l7 _! n- t8 S- x% j3 J. ZYou are implementing WAN access for an enterprise network while runningapplications that require a fully meshed network, which two design standardsare appropriate for such an environment? (Choose two.)

A.   A centralized DMVPN solution to simplify connectivity for the enterprise.
4 t: s  K% M2 wB.    A dedicated WAN distribution layer to consolidateconnectivity to remote sites.
C.    A collapsed core and distribution layer to minimize costs.
4 K; g6 l2 x5 z$ x" wD.    Multiple MPLS VPN connections with static routing.
% B2 b! M& c7 OE.    Multiple MPLS VPN connections with dynamic routing.

Which task do you need to perform first when you configure IP SLA totroubleshoot a network connectivity issue?

A.    Specify the test frequency.
B.    Enable the ICMPecho operation.
1 n2 m( `5 n! B' Z' V9 h, m3 m+ M1 mC.    Schedule the ICMP echo operation.
( g: D) q/ z5 k, T! ^D.    Verify the ICMP echo operation.

Which protocol does VRF-Lite support?

A.    IS-IS
9 }! w$ b! D- E: VB.    ODR
C.    EIGRP
D.    IGRP

Which two features are provided by EIGRP for IPv6? (Choosetwo.)

A.    Backbone areas
B.    SPF algorithm
C.    Partial updates
3 I, ?- I7 `$ ID.    Area border router
9 E" n9 `, _" A' q- ^& [E.    Scaling

) u; m. t+ @8 e& G3 |/ YWhich IP SLA operation can be used to simulate voice traffic on a network?

A.    TCP connect
$ J# p2 T, i1 s2 [B.    UDP-jitter
& q& \* t2 N( o* s# D8 z8 kC.    ICMP-echo
6 Q1 U8 D- }4 V3 n' H: U# o' ?D.    ICMP-jitter

What happens when two EIGRP peers have mismatched K values?

A.    The two devices are unable to correctlyperform equal-cost routing.
B.    The two devices fail to perform EIGRP graceful shutdownwhen one device goes down.
" E. T! j: I* O/ r0 dC.    The two devicesfail to from an adjacency.
D.    The two devices are unable to correctly performunequal-cast load balancing.

$ i/ ~1 t. f6 y" ~3 fWhich location within the network is preferred when using a dedicated route forCisco IP SLA operations?

A.    user edge
0 c! S3 o: d$ O) eB.    provider edge
9 X, G  f/ C+ PC.    access edge
D.    distribution edge

  @- l0 Z+ K! g: qWhich protocol is used in a DMVPN network to map physical IP addresses tological IP addresses?

A.    BGP
9 a  k( d+ [1 s: D+ Q4 cB.    LLDP
9 d0 h7 @& n% K% kC.    EIGRP
D.    NHRP

. {0 B% F) F# tAn engineer is configuring a network and needs packets to be forwarded to aninterface for any destination address that is not in the routing table. Whatshould be configured to accomplish this task?

A.    set ip next-hop
B.    set ip defaultnext-hop
C.    set ip next-hop recursive
D.    set ip next-hop verify-availability

2 w$ F: i+ G/ h, i9 uWhich protocol does MPLS use to support traffic engineering?

A.    Tag Distribution Protocol
B.    ResourceReservation Protocol
C.    Border Gateway Protocol
D.    Label Distribution Protocol

Which IGPs are supported by the MPLS LDP autoconfiguration feature?

A.    ISIS and RIPv2
B.    RIPv2 and OSPF
C.    OSPF and ISIS
: g; r& N4 a  A7 x3 [0 T4 w3 \- |3 fD.    OSPF and EIGRP

$ b( j# w4 S( E+ t& q6 i0 N5 \What does the PE router convert the IPv4 prefix to within an MPLS VPN?

A.    48-bit route combining the IP and PErouter-id.
) ]( |* M" z) J+ u# h. T& j$ H. DB.    VPN-IPv4 prefix combined with the 64-bit routedistinguisher.
C.    eBGP path association between the PE and CE sessions.
D.    Prefix thatcombines the ASN, PE router-id, and IP prefix.

An engineer needs dynamic routing between two routers and is unable toestablish OSPF adjacency. The output of the show ip ospf neighbor command showsthat the neighbor state is EXSTART/EXCHANGE. Which action should be taken toresolve this issue?

A.    match the passwords
$ F5 o% {' l6 iB.    match the hello timers
C.    match the MTUs
D.    match the network types

slourock91

/ R# f" i2 X( X- O/ B$ w8 V; O
9 L! I9 m' k' h0 c* r

slourock91

lyp123

congratulation！