- 积分
- 105
- 鸿鹄币
- 个
- 好评度
- 点
- 精华
- 最后登录
- 1970-1-1
- 阅读权限
- 20
- 听众
- 收听
助理工程师
 
|
发表于 2017-11-24 08:20:58
|
显示全部楼层
我找到的type of tennel mode, 我觉得如果有ipv6ip, 就不该再选6投 和ISTAP
/ U; ~6 j. z, W, eDetermine the tunnel mode command keyword, if appropriate.8 R w; C/ N% V% a( u' E8 [7 z8 [' f! T
The table below shows how to determine the appropriate keyword to be used with the tunnel mode command.9 g, o$ t& @. \$ X
Table 1 Determining the tunnel mode Command Keyword& m0 ~8 G) ~# p: Q! {/ k
dvmrp
- t0 {0 o0 K) QUse the dvmrp keyword to specify that the Distance Vector Multicast Routing Protocol encapsulation will be used.% w# |* n f5 m( M
gre ip" \5 h( @/ s7 J1 J
Use the gre and ip keywords to specify that GRE encapsulation over IP will be used.
9 z# T4 y% Z' Jgre ipv6
- n# f4 j; S; E1 K9 |( {Use the gre and ipv6 keywords to specify that GRE encapsulation over IPv6 will be used.9 C' Y$ v% x7 v4 u
ipip [decapsulate-any]- W- R; G$ w) L
Use the ipip keyword to specify that IP-in-IP encapsulation will be used. The optional decapsulate-any keyword terminates any number of IP-in-IP tunnels at one tunnel interface. Note that this tunnel will not carry any outbound traffic; however, any number of remote tunnel endpoints can use a tunnel configured as their destination.
# W2 _! t1 n F5 Q7 G; Uipv6
& {* u; Q* l0 E1 j5 mUse the ipv6 keyword to specify that generic packet tunneling in IPv6 will be used.0 r' x7 y3 Q/ O6 A
ipv6ip
7 l) \! n9 F1 j1 p" r2 Z, jUse the ipv6ip keyword to specify that IPv6 will be used as the passenger protocol and IPv4 as both the carrier (encapsulation) and transport protocol. When additional keywords are not used, manual IPv6 tunnels are configured. Additional keywords can be used to specify IPv4-compatible, 6to4, or ISATAP tunnels.
6 L8 k& r% v( V& D }$ tmpls
) Q0 h; G/ A1 HUse the mpls keyword to specify that MPLS will be used for configuring traffic engineering (TE) tunnels. |
9#
2017-11-24 08:20:58
回复(0)
收起回复
|