关于策略路由

kongxin850124

在交换机上接口下配置策略路由成功，show run也可以看到，但是为什么我把策略路由no掉，再配置，却看不见了呢？我了解到策略路由跟SDM 有关，BJDT001#show sdm prefer The current template is "desktop access IPv4" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.

  number of unicast mac addresses:                  4K
  number of IPv4 IGMP groups + multicast routes:    1K
  number of IPv4 unicast routes:                    6K
    number of directly-connected IPv4 hosts:        4K
    number of indirect IPv4 routes:                 2K
  number of IPv4 policy based routing aces:         0.5K
  number of IPv4/MAC qos aces:                      0.5K
  number of IPv4/MAC security aces:                 2K

上面是交换机的配置，下面是route-map的配置，只是想把route-map改个名字再应用到接口下，谁知道接口下no掉出来，再配置却出来了?求高人指点，不胜感激

DT001#show route-map
route-map route_voice, permit, sequence 10
  Match clauses:
    ip address (access-lists): route_voice
  Set clauses:
    ip next-hop 192.168.111.6
    ip next-hop verify-availability
  Policy routing matches: 0 packets, 0 bytes

WOLF某某某

请参考如下Cisco文档.3550交换机启用PBR需要
SW(config)#sdm prefer extend-match
仅供参考

WOLF某某某

请参考如下Cisco文档.3550交换机启用PBR需要
SW(config)#sdm prefer extend-match
仅供参考

aleser

拿分走人呵呵，楼下继续！

kongxin850124

WOLF某某某 发表于 2014-10-25 09:18
请参考如下Cisco文档.3550交换机启用PBR需要
SW(config)#sdm prefer extend-match
仅供参考

我的是3750X，ip service，没有这命令

kongxin850124

自顶，没有人帮忙分享下经验吗

零OPEN

帮顶