Pass SP v3.2 lab recently

wqn69

With the great help from this forum, I pass the CCIE-SP lab this week.

I got Lab 2.... again…( yes,there are two set of lab 2), Very much same with SanjanaIE's solution....

Only differences  I found are the troubleshooting -

1 .There are some new errors inject in section 1 compare to the errors reported by someone else.

a.) IPV4 ospf: there is “ip ospf 9 area 1” configured under interface between R5 and R6, this is a hidden error, all the ospf neighbor and route can be learn with this error, but the path selection was impacted.  I did not figure out this problem in the beginning, and it caused the traffic engineering tunnel 26 not up, te62 is fine, it take different path.  Remove it from interface configuration and tunnel 26 up and ping loopback 2 between R2 and R6 are successful.

2. Inter AS VPNv4, in SIte 3,  I redistributed EIGRP to BGP and BGP to EIGRP  in both R9 and R10, based on the interface listed in the table .  And I apply the ip vrf sitemap SOO under the interface toward CE.

3. Between R9 and R20, They clearly said we have to configure "as-type level 1" in R20, and need to reach and show the routes in AS1009, so I use redistribution under address-family ipv4 and IPv6.

4. VPLS is working perfectly  based on the SanjanaIE  solution.  

5. I was configured "autoroute announce" in tunnel 67.

I finish the lab in 6 hours, practise in the real rack help me a lot, it is worth to spend $400 extra to buy 80 hours to practise in the rented rack.  

I will need to catch up with lots of things recently, but will come back when I have some time to answer the question you have, good luck to all of you.

司马大熊

Thanks for sharing~

abook1015

newalt

Congratulations

w0ol1a0

shaoyung

undress

太简单的描述，买广告的嫌疑好大！~