- 积分
- 397
- 鸿鹄币
- 个
- 好评度
- 点
- 精华
- 注册时间
- 2011-1-4
- 最后登录
- 1970-1-1
- 阅读权限
- 30
- 听众
- 收听
初级工程师
![Rank: 3](https://cdn.hh010.com/static/image/common/star_level1.gif) ![Rank: 3](https://cdn.hh010.com/static/image/common/star_level1.gif) ![Rank: 3](https://cdn.hh010.com/static/image/common/star_level1.gif)
|
![](https://cdn.hh010.com/static/image/common/ico_lz.png)
楼主 |
发表于 2011-1-23 00:46:04
|
显示全部楼层
The network shown in the exhibit is running the RIPv2 routing protocol. The network has converged, and
the routers in this network are functioning properly. The FastEthernet0/0 interface on R1 goes down. In
which two ways will the routers in this network respond to this change? (Choose two.)
A. All routers will reference their topology database to determine if any backup routes to the 168.1.0
network are known.
B. Routers R2 and R3 mark the route as inaccessible and will not accept any further routing updates from
R1 until their hold-down timers expire.
C. Because of the split-horizon rule, router R2 will be prevented from sending erroneous information to R1
about connectivity to the 192.168.1.0 network.
D. When router R2 learns from R1 that the link to the 192.168.1.0 network has been lost, R2 will respond
by sending a route back to R1 with an infinite metric to the 192.168.1.0 network.
E. R1 will send LSAs to R2 and R3 informing them of this change, and then all routers will send periodic
updates at an increased rate until the network again converges. |
沙发
2011-1-23 00:46:04
回复(0)
收起回复
|