帧中继上跑OSPF的问题

城管李雄伟

首先利用2个路由器R2 R3模拟帧中继交换机
R1 R4 R5为普通路由器
经测试帧中继环境搭建正常 没有问题
到跑OSPF的阶段 我做了2件事
把R1 R4 R5进入OSPF进程 宣告包括换回口在内的所有网段 且都在AREA 0
然后把R1 R4 R5连接帧中继的接口网络类型全部改成了 P2MP模式
问为什么 R1 上查看 IP OSPF NEI 没有邻居 且ping不通 R4 R5的环回口
P2MP不是不用手动指邻居 也不用手动MAP 直接互通么

宇宙飞侠cwb

DR呢

qq873135086

是不是在接口上no frame-rely inverse-arp了？

kesx

zhangsixian7

P2MP看看不的接口

zhangsixian7

P2MP看看你的接口

城管李雄伟

zhangsixian7 发表于 2013-6-2 12:06
P2MP看看你的接口

R1
Internet Address 12.0.0.1/24, Area 0
  Process ID 100, Router ID 13.0.0.1, Network Type POINT_TO_MULTIPOINT, Cost: 64
  Transmit Delay is 1 sec, State POINT_TO_MULTIPOINT,
  Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
    oob-resync timeout 120
    Hello due in 00:00:14
  Index 2/2, flood queue length 0
  Next 0x0(0)/0x0(0)
  Last flood scan length is 0, maximum is 0
  Last flood scan time is 0 msec, maximum is 0 msec
  Neighbor Count is 0, Adjacent neighbor count is 0
  Suppress hello for 0 neighbor(s)
R4Serial0/0 is up, line protocol is up
  Internet Address 24.0.0.4/24, Area 0
  Process ID 100, Router ID 4.4.4.4, Network Type POINT_TO_MULTIPOINT, Cost: 64
  Transmit Delay is 1 sec, State POINT_TO_MULTIPOINT,
  Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
    oob-resync timeout 120
    Hello due in 00:00:19
  Index 2/2, flood queue length 0
  Next 0x0(0)/0x0(0)
  Last flood scan length is 0, maximum is 0
  Last flood scan time is 0 msec, maximum is 0 msec
  Neighbor Count is 0, Adjacent neighbor count is 0
  Suppress hello for 0 neighbor(s)
R5
Serial0/0 is up, line protocol is up
  Internet Address 35.0.0.5/24, Area 0
  Process ID 100, Router ID 5.5.5.5, Network Type POINT_TO_MULTIPOINT, Cost: 64
  Transmit Delay is 1 sec, State POINT_TO_MULTIPOINT,
  Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
    oob-resync timeout 120
    Hello due in 00:00:22
  Index 2/2, flood queue length 0
  Next 0x0(0)/0x0(0)
  Last flood scan length is 0, maximum is 0
  Last flood scan time is 0 msec, maximum is 0 msec
  Neighbor Count is 0, Adjacent neighbor count is 0
  Suppress hello for 0 neighbor(s)

zhangsixian7

R1
Internet Address 12.0.0.1/24, Area 0
R4Serial0/0 is up, line protocol is up
  Internet Address 24.0.0.4/24, Area 0
R5
Serial0/0 is up, line protocol is up
internet Address 35.0.0.5/24, Area 0
P2MP，但是你的接口ip都不在同一个子网里面

zhangsixian7

改改试试

SIUWILL

有沒有改網絡類型啊...

城管李雄伟

zhangsixian7 发表于 2013-6-3 21:51
改改试试

是的！老子接口IP都不在一个网段里！

zhangsixian7

城管李雄伟 发表于 2013-6-4 22:22
是的！老子接口IP都不在一个网段里！