|
l Implement performance Routing (PfR) to achieve the following polices:
3 v. c* f8 W. {$ P" J0 K- D: j+ g* gl R1 must be the colledge of the master and border
^) P/ p6 m5 E& S9 _7 Y, _4 a! ?l R2 must be the border router.
* Y1 Y# j2 e$ t9 H7 c/ {" B7 i, s7 ^0 c8 v
# Z+ Y1 N, s7 K) c7 A, A& \l Make sure that PfR sessions are established using Loopback0 interfaces only;( o# N! X+ g% ^6 h" c
l specific traffic (marked with DSCP “CS2”) from VLAN_44 TO VLAN_55 must be routed via R1
* k }$ u- ]# ?* d2 f$ i9 N- e# {l another traffic (marked with DSCP “CS4”) from VLAN_44 to VLAN_55 must be routed via R2
, {2 d% d7 {$ `; u( ?4 zl Use extended access-lists with a single entry/ B j' h' a/ z+ J
l Use active probes only;6 T. A6 G2 ~2 H3 L
l The borders should communicate with each other within one hop. Use tunnel 1 required by your solution, you may use any prefix that is not used in your topology.
4 S( y0 I* x8 H' o5 J9 ?% q5 o7 v2 Z' }& x5 \ c0 @
make sure R1 IS G0/0 did not exc...... when the link bandwith is more the 80% and R2 is g0/0 did not exc...... when the link bandwith is more the 90%
2 E2 W2 t' U" a- Q
% c' ]# q; _" w/ a3 F; n9 m" Hconfig a low priority ....... so that make sure the pfr has hight priority level% E; Y4 S2 ]; T7 }
than other..." L( O. u6 Q# a0 u1 M9 u
l The voice traffic should keep constantly monitored to find the best exit.
% C" F7 e; S3 A9 Y- h
! h s" o) o# V6 V6 O# y | 
简体中文
英语
日语
韩语
法语
西班牙语
越南语
泰语
阿拉伯语
俄语
葡萄牙语
德语
意大利语
希腊语
荷兰语
波兰语
保加利亚语
爱沙尼亚语
丹麦语
芬兰语
捷克语
罗马尼亚语
斯洛文尼亚语
瑞典语
匈牙利语
繁体中文
文言文
发表于 2013-1-10 10:39:46
置顶卡
喧嚣卡
变色卡
千斤顶
发表于 2013-1-10 11:34:57
