亚威CCIE RS Lab N4版本需求_2009年1月考试版

思科VUE

亚威CCIE RS Lab N4版本需求_2009年1月考试版        

lo0 : yy.yy.x.x/24
一、 Bridging & Switching
1、VLAN
VLAN NAME Sw1 Sw2 Sw3
11 VLAN_BB1 F0/1,F0/10  
12 VLAN_BB2 F0/4 F0/10
13 VLAN_BB3   F0/10
21 VLAN_A  F0/5
22 VLAN_B F0/2  
23 VLAN_C  F0/2
50 CUSTOMER_1 F0/5 F0/3
100 VLAN_100   
2、Frame-relay
      Configure IP across your frame relay network
    The frame could provide for you is fully meshed. However you must only use the PVC's indicated on Diagram user of any dynamic circuits is not permitted.
    Do not use sub-interfaces for the frame relay links on all routers
    Ensure you can ping all frame relay interfaces (include self)
3、 VTP&VLAN
    Domain: RackYY
    Password: cisco
    SW1 will propagated all VLAN configuration changes to SW2 SW 3 SW4
    In the future these four Switches will be configured as VTP transparent mode. They shouldn’t inspect the VTP domain name and version, and they support unrecognized TLV.(暗示用VTP Ver.2)
4、Trunking
    Trunk among four Switches
    Trunk will be formed unconditionally use ISL choose encapsulation
    Create area Trunk between R6 and SW2, only VLAN BB3 and VLAN B must be allow in the Trunk
5、SVI
VLAN 100
SW1 Y.Y.90.1/24
SW2 Y.Y.90.2/24
SW3 Y.Y.90.3/24
SW4 Y.Y.90.4/24
SW1 F0/3 yy.yy.33.7/24   F0/6  yy.yy.36.7/24
6、802.1Q Tunnel
QinQ at SW1 f0/5 & SW2 f0/3 use VLAN50 name CUSTOMER_1
7、Etherchannel
SW1-SW4’s Ether-Channels will be formed unconditional without using any protocol negotiation
8、load balancing
  R4 is sending packets to many hosts on VLAN_BB2 注意此需求确认使用src-mac还是dst-mac
  Configure SW1 SW2 so that the traffic is efficiently distributed across the physical links



CCIE RS Lab N4版本_2009年1月考试版.pdf (825 KB, 下载次数: 43)

2009-4-8 12:15 上传

点击文件名下载附件

maqizhao

此贴必火,‘留’芳百世.

JamesSmith001

11111