- 积分
- 710
- 鸿鹄币
- 个
- 好评度
- 点
- 精华
- 注册时间
- 2011-5-3
- 最后登录
- 1970-1-1
- 阅读权限
- 40
- 听众
- 收听
中级工程师
|
本帖最后由 zoom123 于 2011-6-21 09:14 编辑
# _& o6 {' ]3 q1 t. z! c/ k8 q
& h6 y/ ~% `* N! ?" U6 x- W1 B1 `, R见图,个人认为选E,是不是啊!: c% c( ~* i9 W! x. r+ N: `* ^
UESTION 2405 _* N" ?. K8 S0 K
When you enable port security on an interface that is also configured with a voice VLAN, what is the
+ P7 c1 I; O7 r! ~" `$ _maximum number of secure MAC addresses that should be set on the port?* c, F4 h5 O, T7 q* t: u, A8 b
A. No more than one secure MAC address should be set.3 P9 m% c9 c; |3 ~
B. The default will be set./ ?+ p3 Z t2 Y! t6 u9 A# I3 e
C. The IP phone should use a dedicated port, therefore only one MAC address is needed per port.. O: X- ~1 h3 Z5 ]' x
D. No value is needed if the switchport priority extend command is configured.
# k( [4 I$ e) h% ?$ B& {9 J2 E* ZE. No more than two secure MAC addresses should be set.
+ Z. h9 l! w# i+ a" D& PAnswer: B
+ Q1 U. E* D h+ s# M/ z" V参见:http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_14_ea1/configuration/guide/swvoip.html#wp1030825
, ^# W0 O+ ^* s, ]% Q' Q When you enable port security on an interface that is also configured with a voice VLAN, you must set the maximum allowed secure addresses on the port to at least two! u7 W: p0 D" }6 W% }# N# |
6 y8 T3 k! G6 l' K q( n- I |
|