CCNA LAB 105: Configuring SNMPv2

小乔

Lab Objective:
The objective of this lab exercise is for you to learn how to implement the SNMP protocol using v2.

Lab Purpose:
Configuring and applying the SNMP protocol is a fundamental skill for any network administrator in order to monitor and gather information about your Cisco device. As a Cisco engineer, as well as in the Cisco CCNA exam, you will be expected to know how to implement SNMP.

Certification Level:
This lab is suitable for ICND2 certification exam preparation.

Lab Difficulty:
This lab has a difficulty rating of 5/10.

Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 10 minutes.


Lab Topology:
Please use the following topology to complete this lab exercise:




Task 1:
Configure hostnames on R1 as illustrated in the topology.

Task 2:
Configure IP addresses on the Gig interface of R1 as illustrated in the topology.

Task 3:
Configure an SNMP Read-Only community called Public. Configure an SNMP Read-Write community called Private.


Task 4:
Configure a standard ACL numbered 10 and add it to the SNMP Private community to allow SNMP access from server 1 only.

Task 5:
Run the show snmp community command and make sure that the right communities are created, and that ACL 10 is being used in the appropriate community.

Configuration and Verification
Task 1:
For reference information on configuring hostnames, please refer to earlier labs.

Task 2:
For reference information on configuring IP addressing, please refer to earlier labs.


Task 3:
R1(config)#snmp-server community Public RO
R1(config)#snmp-server community Private RW
Task 4:
R1(config)#access-list 10 permit 192.168.1.2
R1(config)#snmp-server community Private RW 10
Task 5:
R1#sh snmp  community

Community name: ILMI
Community Index: cisco0
Community SecurityName: ILMI
storage-type: read-only active

Community name: Public
Community Index: cisco2
Community SecurityName: Public
storage-type: nonvolatile active

Community name: Private
Community Index: cisco4
Community SecurityName: Private
storage-type: nonvolatile active    access-list: 10


来源: CCNA LAB 99: Configuring eBGP Advanced
来源: CCNA LAB 100: Configuring GRE Point-To-Point Tunnels
来源: CCNA LAB 101: Configuring IPv6 Traffic Filters
来源: CCNA LAB 102: Implementing HSRP
来源: CCNA LAB 103: Configuring IP SLA
来源: CCNA LAB 104: Configuring SNMPv3

lxzhanshe

谢谢楼主分享！

新野

看看，谢谢！！

lxzhanshe

谢谢分享