- 积分
- 193
- 鸿鹄币
- 个
- 好评度
- 点
- 精华
- 注册时间
- 2014-7-31
- 最后登录
- 1970-1-1
- 阅读权限
- 20
- 听众
- 收听
助理工程师
|
本帖最后由 梁掌门 于 2015-1-19 17:08 编辑
大家有没有遇到过serial口不能使用的情况?
我配置了ip 直连ping都不通,什么原因?
Router(config)#int s2/1
Router(config-if)#ip add 192.168.1.2 255.255.255.0
Router(config-if)#clo
Router(config-if)#clock ra 64000
Router(config-if)#no sh
*Dec 12 00:59:48.706: %LINK-3-UPDOWN: Interface Serial2/1, changed state to up
*Dec 12 00:59:49.716: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial2/1, changed state to up
Router(config-if)#do ping 192.168.1.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Router(config-if)#
*Dec 12 01:00:16.132: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial2/1, changed state to down
|
|