832 1000 @ 老外2 2010-12-20

zizizhe

832 1000 @ 老外2 2010-12-20
almo
/ A2 V) A) h' I- \& J0 S4 ?December 20th, 2010

4 E+ L9 W( u& F7 s
7 x8 K, Q) M, ^* b" FHi everyone ,I passed the TSHOOT exam today with 1000/1000
Question 1
FCAPS–model defined by the International Organization for Standardization (ISO).
ITIL– framework for it prof
TNM–network management model is the Telecommunications Standardization Sector’s (ITU-T)
+ ~) f& X7 }% K7 d, W6 K& ECisco lifecycle–model is often referred to as the PPDIOO model
3 F6 M/ j3 T( qQuestion 2
  x# }7 g  b# G; D) L9 ~) `EEM ‐‐‐‐‐‐‐‐‐‐‐‐‐‐ CLI based for Management and Monitoring
SDM ‐‐‐‐‐‐‐‐‐‐‐‐‐‐ provide a GUI for Administration
# [( ?/ {2 f% d( mFTP ‐‐‐‐‐‐‐‐‐‐‐‐‐‐ Used for Backup and restore
- U/ A6 F& ?2 k( q( JQuestion 3
Two Cisco routers are connected to each other and are enabled CDP. Serial line is up,protocol is also up but cdp neighbor not working. What layer of the OSI model does the problem most likely exist?
Answer:
Data link
( P" X9 D/ n# d; q6 S+ lTrouble Tickets
1-R1 ospf authentication
2-DSW1 vlan access map
+ |7 C. F; ~. h# Y( ~& Q3-R1 acl (Note:acl name edge-security)
# E" Y, `* k& _# C& O: G1 Z4- R1 bgp
5- ASW1 port channel
6- ASW1 port security
. y% D/ c" r4 k* G3 d7-R2 ospfv3
7 X  i  M7 k0 ]: t7 Q% P) E8- ASW1 switchport access vlan 10 (Note: client1 got ip 10.2.1.3 not 169.x.x.x )!!!!! but ping to DSW1 fail, so take care.
9- R4 route redistribution
10-R1 nat (Note:nat acl name nat-traffic)
11-R4 eigrp as
12-DSW1 hsrp
now,at last i am CCNP certified wow wow it sounds good
Thank you Networktut,Naveed,ciscoGuides,shared-lesson,chris and bonus
! e0 v- T6 r$ R. y( h+ P' l0 \5 hsee you all in CCIE and good luck for everyone.
0 x! ^) x5 A  Y) {
+ d- k" y3 P$ w$ j5 Z5 k3 t显示题库未变，老美忙着过圣诞呢～
' I. z1 B" p( u/ ~
1 m/ [+ f8 U2 b# O3 G' x
0 w+ T2 c& n& n6 O& j5 L

buishithahaha

Congratulations!!