利用PowerShell脚本配置DHCP服务器

风嘲笑了落叶

$scope=read-host -prompt "请输入dhcp作用域地址"
$scopename=read-host -prompt "请输入dhcp作用域名称"
$scopedescript=read-host -prompt “请输入dhcp作用域的描述”
$hostname=$env:computername
$FQDNname="$hostname"+"benet.com.cn"
$ipsetStart=read-host -prompt "请输入dhcp分配起始地址"
$ipsetEnd=read-host -prompt "请输入dhcp分配结束地址"
$ipoutstart=read-host -prompt "请输入dhcp排除起始地址"
$ipoutend=read-host -prompt "请输入dhcp排除结束地址"
$gateway=read-host -prompt "请输入的dhcp分配的网关地址"
$dns=read-host -prompt "请输入dhcp分配的DNS地址"
servermanagercmd -i dhcp
get-service dhcpserver |set-service -Startuptype automatic
start-service dhcpserver
netsh dhcp server add scope $scope 255.255.255.0 $scopename $scopedescript
netsh dhcp add server $FQDNname
netsh dhcp server scope $scope add iprange $ipsetStart $ipsetEnd dhcp
netsh dhcp server scope $scope add excluderange $ipoutstart $ipoutend
netsh dhcp server scope $scope set optionvalue 003 ipaddress $gateway
netsh dhcp server scope $scope set optionvalue 006 ipaddress $dns
netsh dhcp server scope $scope set state 1

mhchen2012

Rockyw

感谢楼主分享呀