怎么查看端口的工作方式是 全双工、半双工或者是自动，还有端口带宽，下面到底是哪个

king23656642

怎么查看端口的工作方式是 全双工、半双工或者是自动，还有端口带宽，下面到底是哪个，下面是show端口信息。
高手帮忙解答下！谢谢！
Router#show int fa0/0
FastEthernet0/0 is up, line protocol is up (connected)
  Hardware is Lance, address is 0004.9a87.3a01 (bia 0004.9a87.3a01)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  ARP type: ARPA, ARP Timeout 04:00:00,
  Last input 00:00:08, output 00:00:05, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0 (size/max/drops); Total output drops: 0
  Queueing strategy: fifo
  Output queue :0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out

可比仔

你要在接口下配置带宽和工作模式，bandwidth *；duplex full/half/auto......查看接口好像只看到带宽BW 100000 Kbit，你要看的话，就show run一下吧，接口的配置里有，默认是duplex auto ；speed auto自动协商的

842651379p

BW 100000 Kbit，没看到工作模式，不过默认全双工

chenliang747703

sho run

Big小小

一楼正解

baidu1230

看附件

夜之子、

2,3L正解