|
| | | | | |
|
| | | | |
|
|
|
| | | | | | | ~250m (OM1 - MM 62.5μm)~500m (OM2 - MM 50μm) |
| | | | | | | |
| | | | | | | |
|
| | | | | |
| |
| | | | | |
| |
| | | | | |
| |
Packet Over SONET / SDH (POS) OC-3 / STM-1 |
OC-3 / STM-1 Multimode SR | | | | | | | |
| | | | | |
| |
| | | | | |
| |
| | | | | |
| |
| | | | | |
| |
Packet Over SONET / SDH (POS) OC-12 / STM-4 |
| | | | | |
| |
| | | | | |
| |
| | | | | |
| |
| | | | | |
| |
Packet Over SONET / SDH (POS) OC-192 / STM-64 |
|
| | | | |
| |
| | | | | | | |
| | | | | | | |
以下演示如何在各种平台上面检查DOM/DDM
7600 ——ALL line card
7600#sh inte tenGigabitEthernet 1/1 transceiver
Transceiver monitoring is disabled for all interfaces.
ITU Channel not available (Wavelength not available),
Transceiver is internally calibrated.
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, + : high warning, - : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
--------- ----------- ------- -------- -------- --------
Te1/1 27.5 0.00 50.1 -2.0 -7.8
7600#
Cisco 12000——Engine5 SIP-600
show hw-module subslot X/Y transceiver Z (idprom|status)
GSR#show hw-module subslot 10/0 transceiver 0 idprom
IDPROM for transceiver POS10/0/0:
Description = XFP optics (type 6)
Transceiver Type: = OC192 + 10GBASE-L (65)
Product Indentifier (PID) = QFCT-7081
Vendor Revision = B2
Serial Number (SN) = XXXXXXXXX
Vendor Name = CISCO-AGILENT
Vendor OUI (IEEE company ID) = 00.30.D3 (12499)
CLEI code = WMOTBEVAAB
Cisco part number = 10-1989-02
Device State = Enabled.
Date code (yy/mm/dd) = 06/06/30
Connector type = LC.
Encoding = 64B/66B
SONET Scrambled
NRZ
Minimum bit rate = 9900 Mbits/s
Maximum bit rate = 10500 Mbits/s
GSR#sh hw-module subslot 10/0 transceiver 0 status
The Transceiver in slot 10 subslot 0 port 0 is enabled.
Module temperature = 18.148 C
Transceiver Tx bias current = 29416 uAmps
Transceiver Tx power = -1 dBm
Transceiver Rx optical power = 0 dBm
GSR#
Cisco CRS(-1 / -3)——4x10GE 8x10GE
show controllers TenGigE X/Y/Z/K phy | utility head -n 22
RP/0/RP1/CPU0:CRS#show controllers tenGigE 0/0/0/0 phy | utility head -n 22
XENPAK Information:
===================
Vendor Name: Cisco
Vendor PN: B1G-F4T-X3NP4K
Vendor Rev: 1
Vendor SN: x9j29csi3kd
Package OUI: 00c09820
Vendor OUI: 00000000
Vendor Date Code: 2009010101
Center Wavelength:
chan0 = 1310.00 nm
chan1 = 0.00 nm
chan2 = 0.00 nm
chan3 = 0.00 nm
Digital Optical Monitoring:
Transceiver Temp: 36.406 C
Laser Bias Current: 263.5200 mA
Laser Output Power: 0.7432 mW, -1.3 dBm
Receive Optical Power: 0.3272 mW, -4.9 dBm
RP/0/RP1/CPU0:CRS#
Cisco CRS(-1 / -3)——POS
show controllers SONET X/Y/Z/K | be Opt
RP/0/RP0/CPU0:CRS#show controllers SONET X/Y/Z/K | be Opt
Thu Dec 2 14:48:27.683 CET
Optics type: OC192 + 10GBASE-L
Clock source: internal (actual) internal (configured)
Rx S1: 0x0 Tx S1: 0xf
Optical Power Monitoring (accuracy: +/- 1dB)
Rx power = 0.2621 mW, -5.8 dBm
Tx power = 0.4207 mW, -3.8 dBm
Tx laser current bias = 49.3 mA
RP/0/RP0/CPU0:CRS#
Cisco CRS(-1 / -3)——SIP / SPA
show hw-module subslot X/Y/Z status pluggable-optics K
RP/0/RP0/CPU0:CRS#show hw-module subslot 0/7/1 status pluggable-optics 0
Mon Nov 21 10:40:26.209 CET
SPA 0/7/1 device pluggable-optics 0/0 info:
int Sonet 7/1/0:
State: Enabled
Environmental Information - raw values
Temperature: 36.18 C
Supply voltage: 32998 in units of 100uVolt
Tx bias: 9624 in units of 2uAmp
Tx power: -5 dBm (2491 in units of 0.1 uW)
Rx power: -4 dBm (3014 in units of 0.1 uW)
Transceiver: Enabled
SW TX Fault: unavailable
SW LOS: unavailable
No active alarms
No active warnings
Version Identifier (VID): V01
Product Identifier (PID): SFP-OC48-SR
Part Number (PN): 10-1961-01
CLEI: WM1T2TTAAA
RP/0/RP0/CPU0:CRS#
Cisco CRS(-1 / -3)——4x10GE IPoDWDM
show controllers dwdm X/Y/Z/K
RP/0/RP0/CPU0:CRS#show controllers dwdm 0/0/0/0 optics
Optics Status
Optics Type: Cisco 10Gb DWDM
Wavelength Info: C-Band, MSA ITU Channel=37, Frequency=194.30THz, Wavelength=1542.936nm
TX Power = 4.82 dBm
RX Power = -14.99 dBm
RP/0/RP0/CPU0:CRS#
Juniper JUNOS devices——All linecards
show interfaces diagnostics optics X/Y
user@host> show interfaces diagnostics optics so-7/0/0
Physical interface: so-7/0/0
Link : 0
Laser bias current : 50.776 mA
Laser output power : 0.4030 mW / -3.95 dBm
Laser temperature : 29.0 degrees C / 84.2 degrees F
Laser rx power : 0.4671 mW / -3.31 dBm
Laser bias current high alarm : Off
Laser bias current low alarm : Off
Laser bias current high warning : Off
Laser bias current low warning : Off
Laser output power high alarm : Off
Laser output power low alarm : Off
Laser output power high warning : Off
Laser output power low warning : Off
Laser temperature high alarm : Off
Laser temperature low alarm : Off
Laser temperature high warning : Off
Laser temperature low warning : Off
Laser rx power high alarm : Off
Laser rx power low alarm : Off
Laser rx power high warning : Off
Laser rx power low warning : Off
Module not ready alarm : Off
Module power down alarm : Off
Tx data not ready alarm : Off
Tx not ready alarm : Off
Tx laser fault alarm : Off
Tx CDR loss of lock alarm : Off
Rx not ready alarm : Off
Rx loss of signal alarm : Off
Rx CDR loss of lock alarm : Off
Laser bias current high alarm threshold : 130.000 mA
Laser bias current low alarm threshold : 10.000 mA
Laser bias current high warning threshold : 120.000 mA
Laser bias current low warning threshold : 12.000 mA
Laser output power high alarm threshold : 0.8910 mW / -0.50 dBm
Laser output power low alarm threshold : 0.2230 mW / -6.52 dBm
Laser output power high warning threshold : 0.7940 mW / -1.00 dBm
Laser output power low warning threshold : 0.2510 mW / -6.00 dBm
Laser temperature high alarm threshold : 90.0 degrees C / 194.0 degrees F
Laser temperature low alarm threshold : -5.0 degrees C / 23.0 degrees F
Laser temperature high warning threshold : 85.0 degrees C / 185.0 degrees F
Laser temperature low warning threshold : 0.0 degrees C / 32.0 degrees F
Laser rx power high alarm threshold : 1.2589 mW / 1.00 dBm
Laser rx power low alarm threshold : 0.0323 mW / -14.91 dBm
Laser rx power high warning threshold : 1.1220 mW / 0.50 dBm
Laser rx power low warning threshold : 0.0363 mW / -14.40 dBm
简体中文
英语
日语
韩语
法语
西班牙语
越南语
泰语
阿拉伯语
俄语
葡萄牙语
德语
意大利语
希腊语
荷兰语
波兰语
保加利亚语
爱沙尼亚语
丹麦语
芬兰语
捷克语
罗马尼亚语
斯洛文尼亚语
瑞典语
匈牙利语
繁体中文
文言文
发表于 2012-6-9 10:40:13
置顶卡
喧嚣卡
变色卡
千斤顶
