懂得华为设备的大侠进来帮个忙！谢谢！

xiaobailong653

因为工作上的需要我想知道华为交换机做完镜像配置后在display current-configuration中显示的情况！还有就是做完MPLS后display current-configuration的显示情况，还有就是用那些命令查看MPLS是否做好了，还有反馈出来的信息是什么？希望有这方面经验的人能够给我提供这些数据，在此先谢过了！

lqlzhce

<LSRA> display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status LAM SsnRole SsnAge KASent/Rcv
------------------------------------------------------------------------------
3.3.3.9:0 Operational DU Passive 0000:00:01 6/6
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
<LSRA> display mpls ldp remote-peer
LDP Remote Entity Information
------------------------------------------------------------------------------
Remote Peer Name : LSRC
Remote Peer IP : 3.3.3.9 LDP ID : 1.1.1.9:0
Transport Address : 1.1.1.9 Entity Status : Active
Configured Keepalive Hold Timer : 45 Sec
Configured Keepalive Send Timer : ---
Configured Hello Hold Timer : 45 Sec
Negotiated Hello Hold Timer : 45 Sec
Configured Hello Send Timer : ---
Configured Delay Timer : 0 Sec
Hello Packet sent/received : 10/7
Remote Peer Deletion Status : No
Auto-config : ---
------------------------------------------------------------------------------
TOTAL: 1 Peer(s) Found.

[LSRA] display mpls static-cr-lsp
TOTAL : 2 STATIC CRLSP(S)
UP : 2 STATIC CRLSP(S)
DOWN : 0 STATIC CRLSP(S)
Name FEC I/O Label I/O If Stat
Tunnel1/0/0 3.3.3.3/32 NULL/20 -/Atm1/0/0 Up
tunnel2/0/0 -/- 130/NULL Atm1/0/0/- Up

[LSRB] display mpls lsp
----------------------------------------------------------------------
LSP Information: STATIC CRLSP
----------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 20/30 Atm1/0/0/Atm2/0/0
-/- 120/130 Atm2/0/0/Atm1/0/0

xiaobailong653

lqlzhce 发表于 2012-3-2 17:02

                               
登录/注册后可看大图

display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), S ...

看到你的回复了，非常感谢！还想问一下有没有display current-configuration关于MPLS的信息呀？

lqlzhce

xiaobailong653 发表于 2012-3-2 17:12

                               
登录/注册后可看大图

看到你的回复了，非常感谢！还想问一下有没有display current-configuration关于MPLS的信息呀？

看看这个吧 应该有帮助