|
感觉除了常识 把这些都弄明白了CCNA就差不多了...
ip default-network 0.0.0.0 ?
RIP network mask?
WAN Frame Relay(PVC map , DLCI, rARP, NBMA, lmi), HDLC, PPP(CHAP, PAP) auth
WAN show, debug
Routing RIPv2, EIGRP, OSPF route summarization!!!
DHCP
Telnet auth setup
Loopback interface
UTP cable pin 1,2,3,6
NAT inside/outside
ACL dynamic
OSPF LSA? Area range? Neighbor? Connections (NBMA? Serial? Frame Relay? Multi Access)? Routing info update condition? Process identifier? Adjacency conditions? Cost? DR election higher priority? Media NBMA restrictions PPP? Process ID 1-65536, Area ID 0-4294967295
EIGRP AS number range? summary at classful boundry? cost? AD vs FD for fesible successor? no auto-summary? passive-interface
CIDP, VLSM, classful, classless
ports
VLAN creation
Routing metric/cost, AD
Routing protocols administrative distance
Routing protocols timers
Routing protocols show, debug
routing protocols media restrictions
routing protocols multicase address ipv6 ipv4
routing protocols passive
portfast, uplinkfast, bpduguard, bpdufilter
discontiguous network, RIPv2
STP root election, RSTP election, blocking Q107, designated port!!Q263, priority, bandwidth BPDU, 802.1d, 802.1w, designated port vs root port, PVST..., RSTP, 802.1D, point-to-point?
priority range <0-61440> bridge priority in increments of 4096, lower the better
DMZ setup?
IPv6 transition methods(tunneling), addressing, EUI-64, autoconfig
IOS configuration register, enter ROMMON, boot
set Router interfaces in VLAN
VTP/ Trunk
enable QOS globally and on interfaces
T E OC carrier
|
|