顺应CCIEv4.0，CCNP将在2009年末重大改版

admin

本人从思科(中国)认证部门 了解到，顺应CCIEv4.0，CCNP将在2009年末重大改版！！
更改时间为2009年(西方 北美等时间)圣诞节左右，
原有科目：

CCNP Prerequisites
Valid CCNA certification
CCNP Exams & Recommended Training
Required Exam(s)	Recommended Training
642-901 BSCI	Building Scalable Cisco Internetworks (BSCI)
642-812 BCMSN	Building Cisco Multilayer Switched Networks (BCMSN)
642-825 ISCW	Implementing Secure Converged Wide Area Networks (ISCW)
642-845 ONT	Optimizing Converged Cisco Networks (ONT)
OR
Required Exam(s)	Recommended Training
642-892 Composite	Building Scalable Cisco Internetworks (BSCI) Building Cisco Multilayer Switched Networks (BCMSN)
642-825 ISCW	Implementing Secure Converged Wide Area Networks (ISCW)
642-845 ONT	Optimizing Converged Cisco Networks (ONT)

考试科目和考试代号有重大调整；将完全跟上新版CCIE V4.0的潮流：

1、高级路由Route v1.0 考试编号：642-902 (跟之前的没多少变化,可能会把ISCW的部分内容往这里调 在EIGRP出现部分MPLS VPN 而IS-IS和IPv6 可能组播放回到交换！)
2、多层交换Switch v1.0 考试编号：642-813 (基本上无多少变化 应该是把QOS放回来)
3、安全排错TShoot v1.0 考试编号：642-832 (这门顺应CCIE v4.0考试标准的2个小时排错）

                               
登录/注册后可看大图

得到消息称：考试费用将有部分下调！请大家继续关注！
(我们来自狼的团队继续延伸狼的文化！56cto_CCIE备考群：65676943 须笔试通过审核方可入群)
------------------------------------------
以下是CCIE  路由与交换 实验考试 v4.0 的考试大纲(2009年10月18日起实行)：
英语机试面试+2小时排错+机架上Lab实验考试

1.00	Implement Layer   2 Technologies	√
1.10	Implement Spanning Tree Protocol (STP)
	(a) 802.1d
	(b) 802.1w
	(c) 801.1s
	(d) Loop guard
	(e) Root guard
	(f) Bridge protocol data unit (BPDU) guard
	(g) Storm control
	(h) Unicast flooding
	(i) Port roles, failure propagation, and loop guard operation
1.20	Implement VLAN and VLAN Trunking Protocol (VTP)
1.30	Implement trunk and trunk protocols, EtherChannel, and load-balance
1.40	Implement Ethernet technologies
	(a) Speed and duplex
	(b) Ethernet, Fast Ethernet, and Gigabit Ethernet
	(c) PPP over Ethernet   (PPPoE)
1.50	Implement Switched Port Analyzer (SPAN), Remote Switched Port Analyzer (RSPAN), and flow control
1.60	Implement Frame Relay
	(a) Local Management   Interface (LMI)
	(b) Traffic shaping
	(c) Full mesh
	(d) Hub and spoke
	(e) Discard eligible   (DE)
1.70	Implement High-Level   Data Link Control (HDLC) and PPP
2.00	Implement IPv4
2.10	Implement IP version   4 (IPv4) addressing, subnetting, and variable-length subnet masking (VLSM)
2.20	Implement IPv4   tunneling and Generic Routing Encapsulation (GRE)
2.30	Implement IPv4 RIP version 2 (RIPv2)
2.40	Implement IPv4 Open Shortest Path First (OSPF)
	(a) Standard OSPF areas
	(b) Stub area
	(c) Totally stubby area
	(d)   Not-so-stubby-area (NSSA)
	(e) Totally NSSA
	(f) Link-state advertisement (LSA) types
	(g) Adjacency on a point-to-point and on a multi-access network
	(h) OSPF graceful restart
2.50	Implement IPv4 Enhanced Interior Gateway Routing Protocol (EIGRP)
	(a) Best path
	(b) Loop-free paths
	(c) EIGRP operations when alternate loop-free paths are available, and when they are not available
	(d) EIGRP queries
	(e) Manual summarization and autosummarization
	(f) EIGRP stubs
2.60	Implement IPv4 Border Gateway Protocol (BGP)
	(a) Next hop
	(b) Peering
	(c) Internal Border Gateway Protocol (IBGP) and External Border Gateway Protocol (EBGP)
2.70	Implement policy   routing
2.80	Implement Performance Routing (PfR) and Cisco Optimized Edge Routing (OER)
2.90	Implement filtering, route redistribution, summarization, synchronization, attributes, and other advanced features
3.00	Implement IPv6
3.10	Implement IP version 6 (IPv6) addressing and different addressing types
3.20	Implement IPv6  neighbor discovery
3.30	Implement basic IPv6 functionality protocols
3.40	Implement tunneling techniques
3.50	Implement OSPF version 3 (OSPFv3)
3.60	Implement EIGRP version 6 (EIGRPv6)
3.70	Implement filtering and route redistribution
4.00	Implement MPLS Layer 3 VPNs
4.10	Implement Multiprotocol Label Switching (MPLS)
4.20	Implement Layer 3 virtual private networks (VPNs) on provider edge (PE), provider (P), and customer edge (CE) routers
4.30	Implement virtual routing and forwarding (VRF) and Multi-VRF Customer Edge (VRF-Lite)
5.00	Implement IP Multicast
5.10	Implement Protocol   Independent Multicast (PIM) sparse mode
5.20	Implement Multicast   Source Discovery Protocol (MSDP)
5.30	Implement interdomain   multicast routing
5.40	Implement   PIM Auto-Rendezvous Point (Auto-RP), unicast rendezvous point (RP), and   bootstrap router (BSR)
5.50	Implement   multicast tools, features, and source-specific multicast
5.60	Implement IPv6 multicast, PIM, and related multicast protocols, such as Multicast   Listener Discovery (MLD)
6.00	Implement Network   Security
6.01	Implement access   lists
6.02	Implement Zone Based   Firewall
6.03	Implement Unicast   Reverse Path Forwarding (uRPF)
6.04	Implement IP Source   Guard
6.05	Implement   authentication, authorization, and accounting (AAA) (configuring the AAA   server is not required, only the client-side (IOS) is configured)
6.06	Implement Control   Plane Policing (CoPP)
6.07	Implement Cisco IOS   Firewall
6.08	Implement Cisco IOS   Intrusion Prevention System (IPS)
6.09	Implement Secure   Shell (SSH)
6.10	Implement 802.1x
6.11	Implement NAT
6.12	Implement routing   protocol authentication
6.13	Implement device   access control
6.14	Implement security   features
7.00	Implement Network   Services
7.10	Implement Hot Standby   Router Protocol (HSRP)
7.20	Implement Gateway   Load Balancing Protocol (GLBP)
7.30	Implement Virtual   Router Redundancy Protocol (VRRP)
7.40	Implement Network   Time Protocol (NTP)
7.50	Implement DHCP
7.60	Implement Web Cache   Communication Protocol (WCCP)
8.00	Implement Quality of   Service (QoS)
8.10	Implement Modular QoS CLI (MQC)
	(a) Network-Based   Application Recognition (NBAR)
	(b)   Class-based weighted fair queuing (CBWFQ), modified deficit round robin (MDRR), and low latency queuing (LLQ)
	(c) Classification
	(d) Policing
	(e) Shaping
	(f) Marking
	(g) Weighted random   early detection (WRED) and random early detection (RED)
	(h) Compression
8.20	Implement Layer 2   QoS: weighted round robin (WRR), shaped round robin (SRR), and policies
8.30	Implement link   fragmentation and interleaving (LFI) for Frame Relay
8.40	Implement generic   traffic shaping
8.50	Implement Resource   Reservation Protocol (RSVP)
8.60	Implement Cisco   AutoQoS
9.00	Troubleshoot a   Network
9.10	Troubleshoot a   complex Layer 2 network issue
9.20	Troubleshoot a   complex Layer 3 network issue
9.30	Troubleshoot a   network in response to an application problem
9.40	Troubleshoot network   services
9.50	Troubleshoot network   security
10.00	Optimize the Network
10.01	Implement syslog and   local logging
10.02	Implement IP Service   Level Agreement SLA
10.03	Implement NetFlow
10.04	Implement SPAN,   RSPAN, and router IP traffic export (RITE)
10.05	Implement Simple   Network Management Protocol (SNMP)
10.06	Implement Cisco IOS   Embedded Event Manager (EEM)
10.07	Implement Remote   Monitoring (RMON)
10.08	Implement FTP
10.09	Implement TFTP
10.10	Implement TFTP server   on router
10.11	Implement   Switch-module Configuration Protocol (SCP)
10.12	Implement HTTP and   HTTPS
10.13	Implement Telnet

10z1482

不~~错不错

10z1482

楼主福如东海，万寿无疆！

别说朋

连做了系统

邬戎

顶