CCIE求职面试题--BGP

小乔

BGP

► How do I configure BGP?

► How do I configure BGP with the use of a loopback address?

► What is the order of preference of attributes when some or allare applied to one neighbor in BGP?

► What does a next hop of 0.0.0.0 mean in the show ip bgp commandoutput?

► What are the well-known communities of the BGP communityattribute?

► What formats can I use to configure the BGP community attribute?

► How does BGP behave differently with auto-summary enabled ordisabled?

► How can I verify if a BGP router announces its BGP networks andpropagates them to the global BGP mesh?

► When and how should I reset a BGP session?

► Is there any special configuration needed on PIX/ASA to allowBGP sessions through it?

► What is an autonomous system (AS) number and how do I obtainone?

► What is the BGP path selection criteria?

► What is the difference between always-compare-med anddeterministic-med?

► Do internal BGP (iBGP) sessions modify the next hop?

► Do external BGP (eBGP) sessions between confederations modifythe next hop?

► In external BGP (eBGP) sessions, which IP address is sent as thenext hop?

► Does the route reflector change the next hop attribute of areflected prefix?

► How can I announce a prefix conditionally to one ISP only when Ilose the connection to my primary ISP?

► How can I configure BGP to provide load sharing and redundancyin my network?

► How much memory should I have in my router to receive thecomplete BGP routing table from my ISP?

► What are the benefits of configuring BGP peer groups?

► Why do I see the same route twice from the same peer in BGP?

► What is synchronization, and how does it influence BGP routesinstalled in the IP routing table?

► How do I know which Cisco IOS software release supports aparticular BGP feature?

► How can I set the Multi Exit Discriminator (MED) value onprefixes advertised to external BGP (eBGP) neighbors to match the InteriorGateway Protocol (IGP) next hop metric?

► What is the default BGP ConnectRetry timer, and is it possibleto tune the BGP ConnectRetry timer?

► What does r RIB-Failure mean in the show ip bgp command output?

► How can I redistribute internal BGP (iBGP) learned default-route(0.0.0.0/0) route into EIGRP/OSPF/IS-IS?

► How can I filter all IP routes advertised to a BGP neighborexcept the default route 0.0.0.0/0?

► How to resolve the error Protocol not in this image?

► BGP: timer-wheel running slow by 1 ticks appears in the debugoutput.

► Is it possible to track an interface and change the routeavailability?

► How does IP RIB Update allocate memory?

► What is the command to see IPv6 BGP neighbors?

► In regards to the removal of the static route “ip route10.150.0.0 255.255.0.0 Null0”, does no auto-summary in BGP cause all subnets of10.150.0.0 to be advertised?

► Why are there no statistic results when I use the debug bfdevents and debug bfd packets commands?

► Does the router have to be restarted after a new BGP NeighborMaximum Prefix is configured?

► Is there a command to check the advertised routes along with theprepend of the AS-paths?

► How does neighbor soft-reconfiguration inbound command function?

► What does the %BGP-3-NOTIFICATION: sent to neighbor *A.B.C.Dpassive 6/0 (cease) 0 bytes error message mean?

游客，如果您要查看本帖隐藏内容请回复

smlmcww

全是英文啊

F-22

顶顶顶顶

蜗牛花园

看帖顶帖

emuge

111111111111111111

请叫我Age

多谢

shenpei715

够深入，乔帮主威武。

tricchen1

thank you !

静默坚守

zhengzi

学习

superayufan

楼主真的 是非常感谢

registerboy

為了

wyang9311

Thanks!

迷途的小羔羊

楼主真的 是非常感谢

ikez

多谢分享~